Sony Cyber-shot DSC-TX5 Instruction Manual page 5

Note:
This equipment has btwn testt.d and fo/ind to comply with tht' limits for a Ulass B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interl<.mnce in
a residential installation. This equipment generates, uses. and can radiate radio lYequency
energy and. if not installed and used in accordance with the instructions, may cause
Imrmful interl<.mnce to radio communications. However. them is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interl\.rence to radio or television reception, which can be determined by turning the
equipment off and on. the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Uonnect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The supplied interface cable must be used with the equipment in order to comply with the
limits lk)r a digital device pursuant to Subpart B of Part 15 of F(( Rules.
G B
Notice for the customers in the countries applying EU Directives
The' lniln/ifal.-t/ll-Cr of this product is Sony (-_orporation. I-7-1 Konan Minato-ku Tokyo.
108-0075 Japan. The Authorized Representative for EM( and product sal_.ty is Sony
Deutschhmd GmbH. Hedelfinger Strasse 61. 70327 Stuttgart, Germany. For any service or
guarantee matters please refer to the addr_.sses given in separate service or guarantee
documents.
This product has been tested and lkmnd compliant with the limits set out in the EMU
Directive l\)r using connection cables shorter than 3 meters (9.8 feet).
Attention
The ek.ctromagnctic fiehls at the specific fr<.qu_.nck.s may influence, the pictur<' and so/ind
of this unit.
Notice
If static electricity or electromagnetism causes data transfer to discontinue midway (fail),
restart the application or disconnect and connect the communication cable (USB, etc./
again.
GB
5