Table of Contents
Advertisement
global_main.book.book Page 20 Monday, July 4, 2022 1:38 PM
INSTALLATION
20
6
Use the provided tie strap
drain hoses in place.
NOTE
• The drain hose should not be placed higher than
100 cm above the floor. Water in the appliance
may not drain or may drain slowly.
• Securing the drain hose correctly will protect the
floor from damage due to water leakage.
• If the drain hose is too long, do not force it back
into the appliance. This will cause abnormal
noise.
Connecting Hoses to the Drain
Hose Connector
1
Slide the included band clamp onto the end of
the drain hose of the washer.
2
Connect the drain hoses from the washer and
dryer to the drain hose connector. Tighten the
to secure the 2
c
3
4
• Adjust the wire hose clamp to prevent the hose
band clamp
to keep the washer hose in
a
place.
Use the band clamp
on the short drain hose
b
(included) to attach it to the bottom opening of
the drain hose connector.
Connect securely the short drain hose to a floor
gully or a standpipe.
When connecting to a waste spigot, use the
band clamp
to the end of the short drain
c
hose.
105 cm
105 cm
CAUTION
from coming loose or leaking. Failure to do so
could result in flooding. Use of the drain hose
connector helps avoid siphoning, odours, or
improper draining.
Advertisement
Table of Contents
