2
A
B
A
B
Step 3
Before installing a M.2 SSD
module, please loosen the screws to
remove the M.2 heatsink.
*Please remove the protective films
on the bottom side of the M.2
heatsink before you install a M.2
SSD module.
Step 4
Move the standoff based on the
module type and length.
The standoff is placed at the nut
location B by default. Skip Step 4
and 5 and go straight to Step 6 if you
are going to use the default nut.
Step 5
Peel off the yellow protective film on
the nut to be used. Hand tighten the
standoff into the desired nut location
on the motherboard.
Z790 Taichi Lite
61