Table of Contents
Advertisement
Maintaining your appliance
Oven door
Don't hand
Don't hand
clean the
clean the
oven door
oven door
gasket.
gasket.
You may
You may
hand clean
hand clean
the door.
the door.
56 English
5.
Repeat for the right (front and back)
slide mechanism of the rack.
6.
Open and close the rack several times
to distribute the lubricant.
7.
Replace the cap on the lubricant and
shake it again. Turn the rack over and
repeat steps 3, 4, 5, and 6.
8.
Close the rack, turn the rack right-
side-up, and then place in oven. See
Installing the Gliding rack on page 44.
NOTE
Do not spray the gliding rack with cooking
spray or other lubricant sprays.
•
Use soap and water to thoroughly
clean the top, sides, and front of the
oven door. Rinse well. You may use a
glass cleaner on the outside glass of
the oven door. DO NOT immerse the
door in water. DO NOT spray or allow
water or the glass cleaner to enter the
door vents. DO NOT use oven cleaners,
cleaning powders, or any harsh
abrasive cleaning materials on the
outside of the oven door.
•
DO NOT clean the oven door gasket.
The oven door gasket is made of a
woven material which is essential for a
good seal. Care should be taken not to
rub, damage, or remove this gasket.
Removing the oven doors
CAUTION
•
The door is very heavy. Be careful when removing and lifting the door.
•
Use two hands to remove an oven door. For double ovens, repeat the process
for each door.
B
A
Oven door hinge lock in
A.
locked position
B.
Oven door hinge lock in
unlocked position
1.
Open the oven door.
2.
Locate the oven door hinge locks in
both corners of the oven door, and then
rotate the hinge locks toward the oven
door to the unlocked position. If the
door hinge lock is not rotated fully (see
illustration B on the left for an example
of full rotation), you will not be able to
remove the door properly.
3.
Partially close the door to engage the
door latch locks. The door will stop at
this point.
Advertisement
Table of Contents
