Electrolux ERCP3195AW Manual page 15

Table of Contents

Advertisement

Available languages

Available languages

8.1 What to do if...
Problem
The appliance does not op-
erate.
A
or
or
symbol is
shown instead of numbers
on the Temperature Dis-
play.
The lamp does not work.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "Shopping", or
after changing the tempera-
ture.
Water flows inside the re-
frigerator.
Possible cause
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
There is no voltage in the
mains socket.
The door is left open.
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The "Shopping" is switch-
ed on.
This is normal, no error
has occurred.
Food products prevent
the water to flow into the
water collector.
ENGLISH
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electrical
appliance to the mains sock-
et. Contact a qualified electri-
cian.
Close the door. Refer to
"Door open alarm"
Contact the nearest Author-
ised Service Centre (the cool-
ing system will continue to
keep food products cold, but
temperature adjustment will
not be possible).
Close and open the door.
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait few hours and then
check the temperature again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "Shopping function".
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
15

Advertisement

Table of Contents
loading

Table of Contents