Options - AEG FAVORIT 67032 VI User Manual

24 www.aeg.com
1) The pressure and the temperature of the water, the variations of the mains supply, the
options and the quantity of dishes can change the programme duration and the
consumption values.
Information for test institutes
For all the necessary information for test performance. send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC) that is on the rating plate.

5. OPTIONS

Activate or deactivate the op-
tions before the start of a pro-
gramme. You cannot activate or
deactivate the options while a
programme operates.
If one or more options are set,
make sure that the related indi-
cators are on before the pro-
gramme starts.
5.1 ExtraHygiene
This option gives better results for the
hygiene. During the rinsing phase, the
temperature stays at 70 °C for 10 to 14
minutes.
Press the ExtraHygiene button:
• If the option is applicable to the pro-
gramme, the related indicator comes
on.
• If the option is not applicable to the
programme, the related indicator
flashes for some seconds and then
stays off.
5.2 Multitab
Activate this option only when you use
the combi detergent tablets.
This option deactivates the flow of rinse
aid and salt. The related indicators are
off.
The programme duration can increase.
• Press the multitab button, the related
indicator comes on.
• The option stays on until you deacti-
vate it. Press the multitab button, the
related indicator goes off.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Deactivate the multitab option.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the released quantity of rinse
aid.
5.3 Acoustic signals
The acoustic signals operate in these
conditions:
• The programme is completed.
• The level of the water softener is ad-
justed electronically.
• The appliance has a malfunction.
Factory setting: on. You can de-
activate the acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode. Refer to
'SETTING AND STARTING A PRO-
GRAMME'.
2. Press and hold buttons (4) and (5) at
the same time until the indicators of
buttons (3), (4), (5) and (6) flash.
3. Press button (5),
• The indicators of buttons (3), (4)
and (6) go off.
• The indicator of button (5) contin-
ues to flash.