Table of Contents
Advertisement
The original worktop of freestanding appliances has a front-to-back adjustment
of approx. 2 cm. This allows the worktop to be adjusted to match adjacent appli¬
ances or furniture. To do this, proceed as follows:
□ Unscrew and remove both screws that holds the worktop in place. These are
at the rear of the appliance.
□ Move worktop backwards or forwards as required.
□ Replace and tighten both screws.
Under Worktop Installation of Freestanding Machines
□ Freestanding machines can be built under a work surface if the machine's
original worktop has been removed.
NOTE:
The base/height of the machine is not adjustable.
Removal of the Original Worktop:
□ Remove both screws by which the worktop is attached to the machine's rear
wall,
□ Gently push the worktop backwards and lift off.
In order to achieve a better match with the kitchen furniture, a decor panel can
be added. Decor panels should be obtained from the kitchen manufacturer.
If the machine is not fitted with a decor frame as standard, one can be obtained
as an optional extra from AEG through the retailer.
Dimensions of Decor Panel:
H 590 mm x W 581 mm
Rebate Thickness:
Max 4 mm
*2*
2.
Door front
—--3.
Decor Frame
Fig. 24
/'UF1
In order to avoid the decor panel from bowing when fixed to the front of the
dishwasher, you should use a double-sided tape to hold the decor panel firmly
onto the appliance door.
Advertisement
Table of Contents
