Cleaning The Metal Filters; Cleaning And Maintenance; Changing Light Bulbs - Teka NC2 90/70 Instruction Manual

Instructions for use
You can activate or deactivate the cooker
hood by operating the functions shown in the
diagram.
Switch on the extractor fan a few minutes before
you start to cook in order to ensure that a steady
air flow has been established before fumes
appear.
Allow the extractor fan to run for several minutes
after you have finished cooking (between 3 to 5
minutes) in order to expel all the grease from the
outlet duct. This prevents the return of grease,
smoke and smells.
Display
Timer
Decrease selected funtion
Increase selected funtion
Light
Program the working time
1)Switch on the cooker hood and choose
the required aspiration speed.
2)Push 'Timer'.
3)Select the required programming time
from 1 to 99 minutes by using the
buttons '+' and '-'.
4)The display will alternately show the
clock and the remaining programming
time.
The maximum speed 'H' can only be
selected manually and will be changed
automatically to the second speed level
after approximately 10 minutes.

Cleaning the metal filters

During cleaning and maintenance work,
make sure the safety instructions are
complied with.

Cleaning and maintenance

•If your kitchen hood is made of stainless steel,
use proprietary cleaners mentioned in the
product instructions.
•If your kitchen hood is painted, use lukewarm
water and a neutral soap.
•Never use metallic scourers, nor abrasive or
corrosive products.
•Dry the kitchen hood using a cloth that does not
produce fibres.
•Do not use vapour cleaners
Cleaning the hood body
•To remove the filters from their fittings, press
lightly on the locks and then pull them off.
•The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher. In
this case, it is advisable to stack them vertically
to avoid food residues to stick to them.
•Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this will
not affect its fat retention capacity.
•Once clean, leave them to dry off and then fit
them onto the kitchen hood.

Changing light bulbs

Proceed as follows:
•Unscrew the lamp cover.
•Change the broken / burnt out lamp.
•Screw the lamp cover back in.