Cable Box - Zenith IQB56W10G Operating Manual

Cable Box

Some cable services require the use of a cable box to decode pre-
mium channels and pay-per-view. Using the Loop Out to Decoder
option, and programming your remote, you can connect your cable
box so that you only need your MBR remote to control all the
channels. By connecting cable directly to your Entertainment
Machine, then running it out to the cable box and back, you make
the cable box another source to choose from in the Source selec-
tion on your remote.
Locate the Antenna/Cable 2 jack on the
1
back of your TV. Connect the cable that
runs from the wall directly to the jack.
Now find the the Loop Out jack.
Connect the cable from this jack to the
2
Input jack on the back of your cable box.
Locate the Output jack on the back of
3
your cable box. Connect this to the
Antenna/Cable 1 jack on the back of your
TV.
To view the premium stations, set the
4
channel number on your cable box to
HBO, CINEMAX, SHOWTIME, etc. Then
press the Antenna button on your remote
and select the other Cable source
(Ant/Cable 1).
To view the non premium channels press
the Antenna button and select Ant/Cable 2.
Then run Auto Program to check for all
available channels and store them in
memory.
This can be combined with any other
equipment you may want
to hook up. Hook cable directly into the
TV, then to the cable box. From there, the
cable box goes to the next device, down
the line, until the last piece, which con-
nects back to the TV in the
Antenna/Cable 1 jack.
Turn to pages 26-27 to activate EZ
5
Program for your analog signal and to
tune your DTV antenna.
To receive premium channels, run
Auto Program on the second source
that is set to receive channels.
P A G E 1 0
Antenna
Cable TV
wall jack
Signal Splitter
Cable box
In
Out
Rf coaxial wire
(75 ohm)
RF coaxial wire
(75 ohm)
ANT/CABLE2 LOOP OUT ANT/CABLE1
INPUT INPUT
VIDEO
L
S-VIDEO
(MONO)
OUT
R
MONITOR VIDEO 2
INPUT
OUT
DTV/RF
ANTENNA
INPUT
206-3583