Zenith A19A11D Operating Manual page 6

P A G E 6 I N S TA L L AT I O N
Hook Up Your Antenna and VCR to TV
Connect your
off-air
1
antenna and
VCR to your
Entertainment
Machine.
2
3
4
5
S TA N DA R D
Locate the Antenna/Cable jack on
the back of your Entertainment
Machine.
Connect the cable that runs from
the wall directly to this jack,
according to the diagram to the
right.
Remove the back of the remote
and put in two AA batteries.
back of remote
Plug in your TV. Do not plug it
into a switched outlet. Your
Entertainment Machine is
designed to operate on household
current, 120-volt 60 Hertz AC do
not attempt to operate it on DC
Current.
Go to page 8 to Auto Program
your Entertainment Machine.
Remember, when screwing
RF cables onto jacks, clockwise
tightens, and counterclockwise
loosens.
No A/V cables are included with
your Entertainment Machine.
Without A/V cables, most VCRs
will not play videocassettes in
stereo sound.
Flat wire Antenna to TV with VCR
Antenna
Flat wire
(300 ohm)
300/75 ohm
Adapter
TV back
RF coaxial wire
TV back panel
(expanded view)
A/V cables
Audio In Video
not included
Antenna
with TV
Cable
Coaxial wire Antenna to TV with VCR
Antenna
RF coaxial cable
(75 ohm)
TV back
RF coaxial wire
(75 ohm)
not included
with TV
TV back panel
(expanded view)
Audio In Video
Antenna
Cable
VCR back
VCR back AV panel
output
In
switch 3 4
Out Video
Audio
(75 ohm)
not included
with TV
Optional
for 25" and
27" screens
only.
VCR back
VCR back AV panel
output
In
switch 3 4
Out
Video
Audio
A/V cables
not included
with TV
206-3370-A