Connecting To An Audio System - Zenith DVD5201 Operating Manual

Connecting to an Audio System

You can listen to the sound of audio CDs and DVD video discs in stereo.
To VIDEO OUT To AUDIO OUT (L/R)
Audio cable
(supplied)
Video cable
(supplied)
Notes
Refer to the owner's manual of your audio system for operating instructions.
Before you connect the DVD player to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before making any connections.
If you place the DVD player near a tuner or radio, the radio broadcast sound might be distorted. In this case, move the DVD
player away from the tuner and radio.
The output sound of the DVD player has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate
listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.
Turn off the receiver before you connect or disconnect the DVD player's power cord. If you leave the receiver power on, the
speakers may be damaged.
Warning
Do not set the Digital Audio Output of this DVD player to "Dolby Digital" unless you are connecting the DIGITAL OUT jack of this DVD
player to an AV decoder that has the Dolby Digital decoding function. High volume sound may damage your hearing as well as the
speakers (Refer to "Selecting Digital Audio Output" on page 40).
To S-VIDEO OUT
S-video cable (supplied)
If the TV has an S-video input, connect
the DVD player with the S-video cable.
To audio inputs
Audio system
CONNECTIONS
To S-video input
To video input
TV or monitor with
audio/video inputs
PAGE 13