Advertisement
— DISASSEMBLY INSTRUCTIONS
Ce ae How to remove upper side parts
To remove the dust cover
_ ® Open the dust cover and pull it in
the direction of the arrow @ by
holding both sides of the dust cover.
To remove the turntable platter
1. Remove the turntable mat and the
drive motor belt.
2. Lift the turntable platter.
~ Cartridge setscrew
To remove the cartridge
_ 1. Slightly move the tonearm inward.
To remove the 45 r.p.m. adaptor
2. Remove the cartridge setscrew.
1. Remove the turntable platter.
2. Release the 3 claws.
*
When removing the stylus, it is not
necessary to remove the cartridge.
To remove the record size detector
1. Remove the turntable platter.
2. Release the 4 claws.
Drive motor belt
Bottom board
—
How to remove lower side parts
Note: Remove the bottom board first.
To remove the hinges
2)
1. Remove the dust cover.
0
-
3)
2. Release the 2 claws.
4
Claws
=D
/
va
To remove the bottom board
= Tan
=
je
e
Ry) \
\
\__rAg
[fern
¥
Remove the 4 setscrews.
To remove the main circuit board
1. Remove the setscrew @.
2. Remove the shield plate and lift the
main circuit board.
) O
a
RE
8
To remove the switch
.
"
all
e Release the 2 claws.
Shield plate
—
¢
Claws
To remove the turntable drive motor
6
—
To remove the automatic mechanism
i
r
|
plate
e
Lift the turntable drive motor.
re, -
eT
eT
eT,
2. Remove the rod.
To remove the cueing lever
e Remove the setscrew @ and rod.
To remove the start/stop and cueing
button
e Remove the setscrew @.
3. Pull the cartridge in the direction of the arrow.
—
How to remove the tonearm parts
To remove the tonearm
1. Remove the bottom board.
2. Remove the automatic mechanism
plate.
3. Unsolder the 5 lead wires.
4. Slightly move the tonearm towards
the gap.
5. Lift the tonearm base with tonearm.
6. Remove the 2 setscrews (@, @).
Black (GND)
Blue (Lch ©)
White (Lch @)
Red (Rch @)
Green (Rch ©)
To remove the tonearm lifter
1. Remove the tonearm.
2. Remove the adjustment screw, then
the tonearm lifter can be removed.
To remove the base cover
1. Remove the tonearm.
2. Release the 2 claws.
Tonearm
——— =
lifter
Adjustment
setscrew
Note: When
removing the tonearm
lifter and the base
cover, it is not necessary to remove the 5 lead wires.
Advertisement
