York YLAA0041 Installation Operation & Maintenance page 163

Form 150.72-ICOM6
Issue date: 12/19/2023
Option 3: Ambient control type
A M B I E N T
S T A N D A R D
The low ambient cutout is adjustable from 25°F to 60°F
(-3.9°C to 15.6°C).
or
A M B I E N T
L O W A M B I E N T
The low ambient cutout is programmable down to
-10°F (-23.3°C). A low ambient kit and variable
speed fans MUST be installed for this option to be
chosen. If the kit is NOT installed, and low ambi-
ent is selected, low pressure faults and compressor
damage may occur.
Option 4: Local/remote control type
L O C A L / R E M O T E
L O C A L
When programmed for LOCAL, an ISN or RCC con-
trol can be used to monitor only. The micro panel will
operate on locally programmed values and ignore all
commands from remote devices, or through the RS-
485 inputs. The chiller will communicate and send data
to the remote monitoring devices.
or
L O C A L / R E M O T E
R E M O T E
This mode should be selected when an ISN or RCC
control is to be used to control the chiller. This mode
will allow the ISN to control the following items: Re-
mote Start/Stop, Cooling Setpoint, Load Limit, and
History Buffer Request. If the unit receives no valid
ISN transmission for 5 minutes, it will revert back to
the locally programmed values.
Johnson Controls
C O N T R O L
C O N T R O L
M O D E L
M O D E
Option 5: Unit control mode
C O N T R O L
R E T U R N
Unit control is based on return chilled liquid temp.
Return Chilled Liquid Control can only be selected on
units that have 4 to 6 compressors (dual system units).
or
C O N T R O L
L E A V I N G
Option 6: Display units
D I S P L A Y
I M P E R I A L
This mode displays system operating values in Impe-
rial units of °F or PSIG.
or
D I S P L A Y
S I
This mode displays system operating values in Scien-
tific International Units of °C or barg.
Section 7: Unit controls
M O D E
L I Q U I D
M O D E
L I Q U I D
U N I T S
U N I T S
163
7