Headphone Jack; Reverb Level - Peavey Blazer 158 Operating Manual

ENGLISH
J 2 3 4 5 6 7 8 9 10 11
INPUT (1)
The input jack will accept signals from all types of guitar pickups. Be sure to use a high-quality shielded
cable to connect the guitar to the amplifier.
PRE (2)
Controls the volume level of the Normal channel and is not affected by the SuperSat ® or Post Gain controls.
CHANNEL SELECT SWITCH (3)
Allows selection of the Lead or Normal channel. The "in" position of the switch selects the Lead channel
and the "out" position select Normal.
SUPERSAT? (4)
A transistor simulation of tube distortion (soft clipping). To activate the SuperSat effect, Lead channel must
be activated.
POST GAIN (5)
Controls the overall volume level of the Lead channel. The final level adjustment should be made after the
desired sound has been achicved.
PREAMP OUT (6)
The preamp output can be used to route the amplified signal to a mixing console, tape recorder, etc. Connect
the preamp output using a shielded cable to an input of the tape recorder, mixer, etc. This patch does not
affect the operation of the amplifier.
LOW, MID, & HIGH EQ (7)
Passive tone controls that regulate the low, mid and high frequencies, respectively.
HEADPHONE JACK (8)
This stereo jack allows signal to flow to both sides of any stereo headset. A monaural headset may be used,
but is not recommended.
REVERB LEVEL (9)
Controls the overall reverb level.
POWER LED (10)
Illuminates when AC power is being supplied to the amp.
POWER SWITCH (11)
Depress the switch to the "On" position. The red pilot light (LED) will illuminate indicating power is being
supplied to the unit.
WARNING: This unit is connected to the mains power, even if the power switch is off.