Table of Contents
Advertisement
Switching the Source
Parts identification
Fig. 1
[3] Source Switching
[10] @ AUX ON/OFF
Fig. 2
[19] Source Switching (Tape Deck, Tuner}
[20] Source Switching (Multi-CD Player)
Switching the Source on the Main
Unit
Each time button [3] is pressed, the source
changes in the following sequence:
Tape deck — Tuner — Multi-CD player —
OFF
Switching the Source Using the
Remote Controller
Each time button [19] is pressed, the source
changes in the following sequence:
Tape deck — Tuner — OFF
Each time button [20] is pressed, the source
changes in the following sequence:
Multi-CD player — OFF
The source will not be switched to the
tape deck if there is no cassette tape in
the deck.
The source will not be switched to the
multi-CD player if a multi-CD player is not
connected, or if a magazine is not loaded
in the player.
When connecting other audio equipment
to the IP-BUS terminal of the main unit
using the separately sold conversion cord.
When listening to the audic equipment,
carry out the following operations to switch
to AUX mode.
1.While pressing @ of button [10], turn the
ignition key from OFF to ON,
2.Switching sources allows selection of
AUX mode. Therefore, press button [3] to
switch to AUX mode.
Tape — Tuner — Multi-CD player — AUX
— OFF
When performing an operation with the
remote controller, the source is not
switched to AUX.
Switching the Display
Parts Identification
Fig. 1
(5] Display Switching
Fig. 3
[28] Message Display
Switching the Message Display
Display [28] changes as follows each time
button [5] is pressed:
Source and mode symbol — Signal
indicator
When the Unit is Used in Combination
with the "DEQ-P800" Hideaway DSP
When the unit is used in combination with
the "DEQ-P800" Hideaway DSP, display
[28] changes as follows each time button
[5] is pressed:
Source and mode symbol — Signal
indicator — SFC* symbol — Equalizer curve
*SFC: Sound Field Control
+ Display [28] is useful for checking the SFC
and qualizer curve settings.
Advertisement
Table of Contents
