Husqvarna LC 251i Operator's Manual page 14

™
• Push the SavE button to position 1 to start the
function.
™
• Push the SavE button to position 0 to stop the
function.
Note:
™
The SavE function stops automatically if the
ground conditions make it necessary to have a higher
™
output. The SavE function starts automatically again
when the ground conditions let it.
High load function
When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
standard mode when high load is not necessary.
Motor stalling
During operation, the blade and motor can temporarily
stop because of obstacles such as grass blockage
below the cutting cover. If this occurs and you keep the
motor brake handle pushed down, the product restarts
automatically. If the product does not restart in 5-10
seconds, it can be necessary to clean below the cutting
To clean the product on page 16 .
cover. Refer to
WARNING:
product tries to restart automatically for 5-10
seconds. Wait for a minimum of 15 seconds
before you do a check of the cutting cover.
WARNING:
cutting cover, release the motor brake
handle, turn the safety key to 0, remove
the battery and wait for a minimum of
5 seconds. There is a risk of injury if
the obstacle is removed and the product
accidentally starts.
To stop the product
WARNING:
before you let the product out of view.
14
If the motor stops, the
Before a check of the
Turn the safety key to 0
1. Release the motor brake handle to stop the motor.
Note:
For LC 251iS. To stop the drive of the
wheels, release the drive bail.
2. Open the battery lid and turn the safety key to 0.
3. To remove the battery, push the 2 release buttons
and pull out the battery.
4. Charge the battery if it is weak. For more
information, refer to
12 .
To use the product with the grass
catcher
WARNING:
without a grass catcher installed or without
the rear cover closed. Objects can eject and
cause injury to the operator.
To charge the battery on page
Do not operate the product
2207 - 003 - 26.10.2023