AEG TR979M8CS User Manual page 34

34 www.aeg.com
Error code
E50
E90 or E91
EH0
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
13.2 Troubleshooting
Problem
You cannot activate the appliance.
The programme does not start.
Steam programme does not start. The
steam water container indicator lights up.
After a steam programme, clothes are not
sufficiently smooth.
Possible cause
Appliance motor overloaded.
Too much laundry or entrap in the
drum.
Internal fail. No communication be‐
tween electronic elements of the
appliance.
The mains supply is unstable.
The programme was not comple‐
ted. Remove the laundry from the
drum, set the programme and re‐
start the cycle.
The programme was not finished
properly or the appliance stoped
too early. Switch the appliance off
and on again.
If the error code appears again,
contact the Authorised Service
Centre.
When the appliance is showing
EH0, please wait until main supply
is stable than press start. If the ap‐
pliance pause the cycle without
any indication then press the cycle
start. If the warning will occur
check the power cord / socket in‐
tegrity or main supply.
Possible solution
Make sure that the mains plug is connected
to the mains socket.
Check fuse in fuse box (domestic installa‐
tion).
Press Start/Pauze.
Make sure that the appliance door is closed.
Fill water container.
Clean the steam water filter
Note the composition of the fabric.
Set a higher steam level.
Load the machine with fewer clothes, or on‐
ly equivalent ones.
Remedy