Table of Contents
Advertisement
2.
To change a connection to multicast or multi-unicast bundles, click on the vertical line that
goes through the target connection point to open the bundle type editing window.
Note: Unicast bundles are only transmitted to single devices which have been set to the same
bundle number as the transmitting device. Multicast bundles are transmitted to all devices on the
network regardless of their settings, but only bundles with the specified bundle number(s) are
processed. For this reason, multicast bundles make heavy use of network bandwidth and it is
recommended that the maximum number of multicast bundles be limited to 4 (32 channels).
Multi-unicast bundles are only transmitted to up to four devices simultaneously, saving network
bandwidth compared to multicast bundles.
3.
Click "Multicast" to change the connection to multicast, or "Multi-unicast" to change the
connection to multi-unicast.
This completes MY16-CII bundle setup. The MY16-CII can now be used for audio signal transfer.
For information on setting MY16-CII latency and other detailed settings skip ahead to "2. MY16-
CII Device Settings" on page 16.
Connecting MY16-CII Cards and Other CobraNet Devices via the Device Properties
Window
Bundle numbers can be set if the system includes devices not directly supported by the CobraNet
Manager (such as the MY16-C) by using the procedure described below.
1.
Right click on a Tx or Rx block on the border of the Matrix View window to open the pop-
up menu shown below.
CobraNet Manager Lite for Yamaha Owner's Manual
Figure 9: Bundle type editing window
12
Advertisement
Table of Contents
