Storing And Repairing Your Microwave Oven; Replacing The Cooktop/Night Light - Samsung ME21D 6300 Series User Manual

Hide thumbs Also See for ME21D 6300 Series:
Table of Contents

Advertisement

Available languages

Available languages

Storing and repairing your microwave oven

If you need to store your microwave oven for a short or extended period of time,
choose a dust-free, dry location. Dust and dampness may adversely affect the
functionality of the microwave parts.
WARNING
Do not repair, replace, or service any part of your microwave oven yourself. Allow
only a qualified service technician to perform repairs. If the oven is faulty and
needs servicing, or you are in doubt about its condition, unplug the oven from the
power outlet and contact your nearest service center.
Do not use the oven if the microwave oven is damaged, in particular, if the door or
door seals are damaged or the door does not close properly. This can be caused by
a broken hinge, a worn out seal or distorted/bent casing.
Do not remove the oven from its casing.
This microwave oven is for home use only and is not intended for commercial use.

Replacing the cooktop/night light

When replacing the cooktop/night light, make sure that you are wearing gloves to
avoid injury from the heat of the lamp.
Lamp
Lamp
NOTE
To purchase a new LED lamp board, visit an authorized Samsung service center or
call 1-800-SAMSUNG (726-7864).
1.
Unplug the oven or turn off the power
at the main power supply.
Remove the screw from the light cover
2.
and lower the cover.
3.
Disconnect the wire connectors.
4.
Remove the screw securing the LED
lamp board.
Replace the LED lamp board.
5.
Replacing the oven light
When replacing the oven light, make sure that you are wearing gloves to avoid
injury from the heat of the lamp.
1.
Unplug the oven or turn off the power
at the main power supply.
2.
Open the door.
3.
Remove the vent cover mounting
screws (2 middle screws).
4.
Slide the vent grille to the left, then pull
it straight out.
5.
Remove the charcoal filter, if present.
6.
Remove the screw securing the lamp
cover.
7.
Remove the lamp by pulling it out
gently.
8.
Replace the lamp with a 50 W halogen
lamp.
9.
Replace the lamp holder.
10. Replace the vent grille and re-insert the
2 screws.
11. Plug the oven in or turn on the power
at the main power supply. Reset the
clock.
English 33

Advertisement

Table of Contents
loading

Table of Contents