Table of Contents
Advertisement
Option B: No waste disposer – no air gap
A
A. Waste tee
B. Drain trap
1.
Fit rubber end (A) of drain hose to
1
waste tee and cut if needed.
NOTE: Do not cut ribbed section.
A
2.
Attach rubber end of drain hose to
waste tee with a large drain hose clamp
(provided). Use pliers to squeeze clamp
open and move into position. If the
drain hose was cut, use a 1
(38 mm to 50 mm) screw-type clamp
(not provided).
22
D
C
B
Drain hose
C.
Large drain hose clamp
D.
1
/
" to 2"
2
Option C: Waste disposer – with air gap
B
C
A. Screw-type
clamps
B. Disposer inlet
C. Drain trap
D. Drain hose
Helpful Tip: Remove disposer knockout plug.
1.
Using a hammer and screwdriver,
1
knock plug into disposer.
2.
Use needle-nose pliers to remove plug.
2
3.
Connect rubber end (A) of drain hose to
3
air gap and cut if needed.
NOTE: Do not cut ribbed section.
A
4.
Attach drain hose to air gap with large
4
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position. If the drain hose was cut, use
a 1
screw-type clamp (not provided).
5.
Use a rubber hose (not provided) with
5
screw-type clamps (not provided) to
connect from air gap to disposer inlet.
G
A
F
E
D
Rubber hose connector
E.
Large drain hose clamp
F.
Air gap
G.
" to 2" (38 mm to 50 mm)
1
/
2
Advertisement
Table of Contents
