Honeywell MPA2C3 User Manual page 59

Hard anti passback violation notification and the user is denied entry.
Soft - Validates IN/OUT status before allowing entry. A second swipe of a card at
the
same type of reader (IN/OUT) causes a Soft anti-passback violation notification
but the user is allowed entry.
Out - Applies to readers located inside the anti-passback-controlled area. Card-
holders use these readers when attempting to exit the anti-passback-controlled
area.
Note: With anti-passback, limited use and trace cards do not apply. In - Applies to readers
located outside the anti-passback-controlled area. Card holders use these readers
when attempting to enter the anti-passback-controlled area.
5. Select a Duress Output value
Configures the output that triggers when a card holder enters a duress PIN at a key-
pad/card reader. A duress PIN is the PIN a user enters at a keypad when being
forced (for example, during a robbery) to open a door. The card holder enters a PIN
that is either one number higher or lower than the correct PIN. This PIN opens the
door, but it also triggers the designated duress output and produces an alarm
event.
For example, if the PIN is 2222, entering either 2221 or 2223 opens the door, but trig-
gers a duress pulse and generates an alarm. In this way, the card holder notifies
others without detection by the unauthorized person.
Note: A PIN ending in 0 (for example, 2320) will only trip a duress output when a 1 is used
in place of the 0 (for example, 2321).
Note: The duress output feature requires the following configurations:
•
•
6. Enable or Disable Reader B. The default setting is Disabled. A confirmation
7. Click Save.
Note: Should a conflict arise among the schedules set in the Access Modes and Schedules
section, priority is given in the following order:
•
•
•
•
MPA2C3 User Manual
Duress must be enabled on the Panel Configuration > Settings >mBehaviour
Figure 2-10
Settings tab. See
A schedule/schedule must be selected for Card and PIN in the Doors
configuration.
message appears. Click OK to enable Reader B. Use an Reader B if a door has
readers on both sides (inside and outside).
Disable Reader
Lockdown Reader
Card and PIN
Card or PIN
page 31.
on
59