Rear Panel Layout - Cisco Expressway CE1300 Installation Manual

Rear Panel Layout

This section details the rear panel layout, LEDs and ports.
Figure 2: Rear view of the Cisco Expressway
Table 5: Rear panel LEDs and components
1 In Riser 1 on the left-hand side, a Low-profile PCIe slot houses two SFP ports:
• The left port is LAN1 (NIC1) in the Expressway user interface.
• The right port is LAN2 (NIC2) if used in the interface.
2 Power supplies PSU 01 and PSU 02. The second power supply provides 1+1 redundancy.
3 Modular LAN on Motherboard (mLOM) card slot (not populated).
4 System identification button/LED.
5 USB 3.0 ports (two).
6 Dual 1-Gb/10-Gb Ethernet ports (LAN3 and LAN4):
• LAN3 Left Hand Port→ Expressway Dedicated Management Interface (DMI) port
– if configured
• LAN4 Right Hand Port→ Not currently used by Expressway.
Note
C H A P T E R
With all Expressway version releases on CE1300, optional support is available
for a Dedicated Management Interface (DMI), which uses LAN3 as an
out-of-band management interface.
Cisco Expressway CE1300 Appliance Installation Guide (X14.3.1)
4
11