Cub Cadet 60 Operator's Manual page 13

WARNING: Before performing any type
of maintenance on the machine, wait for
all parts to stop moving and disconnect
the spark plug wire. Failure to follow
this instruction could result in personal injury or
property damage.
Removing the Flail Screen
If the discharge area becomes clogged, remove the flail
screen and clean area as follows:
1. Stop the engine. Make certain the chipper/shredder
vacuum has come to a complete stop.
2. Before unclogging the discharge chute, disconnect
and ground the spark plug wire to retaining post.
3. Remove the vacuum bag from the unit as instructed
in the OPERATION section to obtain access to flail
screen.
4. Remove self tapping screw on right side of unit that
attaches to the flail screen. It may be necessary to
remove the hose bracket hanger to get access to the
screw. See Figure 5-1.
5. Remove hex screw on top of rear housing near
mounting bracket and the flange lock nut that
secures flail screen. See Figure 5-1.
6. Remove and clean the screen by scraping or wash-
ing with water. See Figure 5-2.
7. Reinstall the screen.
Figure 5-1
Figure 5-2
13

Maintaining
Your
Chipper
Shredder
Vacuum