Yamaha CDR-HD1300 Owner's Manual page 21

5.
Press COPY once.
The following message appears on the display, and this unit
enters the copy standby mode. Copying has not been started yet
at this stage.
ALL SYNC
ALL SYNC
6.
Start copying.
Press w/d (w on the remote control) to start copying.
ALL SYNC
The copying conditions (initial settings) are as follows:
• Copy Method: "Digital Copy"
• Copy Level: 0dB
• Copy Speed: "Best Effort"
To change the settings, see "Copying menu setting" on page 18.
Notes
• It takes a few seconds for this unit to become ready to start
copying after w/d (w on the remote control) has been
pressed.
• This unit may create some vibration and rotation noise while
performing the copying process by rotating a CD at high
speed. If this problem occurs, lower the copying speed to
decrease the vibration and rotation noise. (See "Copy Speed"
on page 19.)
To cancel copying, press a.
When copying has been completed, the operation of
the HDD and the CD automatically stops.
REC
DIG L TOC GROUP
dB –30 –10 –6 –2 0
CD
R
REC
L
DIG TOC GROUP
dB –30 –10 –6 –2 0
CD
R
REC
L
DIG TOC GROUP
dB –30 –10 –6 –2 0
CD
R
COPYING FROM A CD ONTO THE HDD
CD TEXT
If the CD to be copied contains CD TEXT that can be copied,
CD TEXT is automatically copied when the CD is copied onto
the HDD.
Output of the signals during copying
• During copying at 1x speed, signals are output both from the
ANALOG LINE OUT (PLAY) jack and from the DIGITAL
OUTPUT (OPTICAL/COAXIAL) jacks.
• During copying at 2x speed, signals are output only from the
ANALOG LINE OUT (PLAY) jack.
• During copying at 4x or more speed, signals are output neither
from the ANALOG LINE OUT (PLAY) jack nor the
DIGITAL OUTPUT (OPTICAL/COAXIAL) jacks.
15
E-