Setting Up The Speakers - Yamaha NS-AP7800E Owner's Manual

Attaching the pedestals to the front speakers
Attach the pedestal to the front speaker as shown below by using screws supplied with the product.
Non-skid pad
Wall mounting the surround speakers
When mounting the speakers on a wall, attach one of the wall mounting rubber pads provided near each of the
corners on the rear surface of the speaker to prevent the speaker cable from being caught between the wall
and the speaker.
You can also use the screw holes on the back of the speaker for
installing the speakers on commercially available speaker brackets.
3-11/16" (93.5 mm)
When using speaker brackets to mount the speakers on a wall or ceiling, it is strongly recommended that
safety wire, which may be included with the bracket, be used between the speaker and the bracket to prevent
the speaker from falling.
Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting
bracket on the protruding screws.
Make sure that the screws are securely caught by the narrow sections of the "key hole" opening.
WARNING
Surround speaker weighs 3.53 lbs (1.6 kg). Do not mount the speakers on thin plywood or a wall with soft
surface material, since the screws may pull away from the surface and fall. This will damage the speakers
and can cause personal injury.
Do not mount the speakers on a wall with nails, adhesives, or any other unstable hardware. Long-term use
and vibrations may cause them to fall.
To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or floor
molding.
Secure installation is the purchaser's responsibility.
4
NS-AP7800M/NS-AP7800E

SETTING UP THE SPEAKERS

Screw
Bottom of the
front speaker
A screw with a diameter of
1/4" can be used.
(Hole depth: 9/32")
2-3/8" (60 mm)
2
1
Philips driver
Non-skid pads
Pedestal
Wall / wall support
Tapping screw
(Available at the hardware store)
Min
1"
7/32"