LG WTT1410OM Owner's Manual page 10

INSTALLATION
10
3
Remove the tape securing the power supply
cord and drain hose.
4
Remove the inlet hose and filter from the
accessory bag.
Installation Location
Installation Area
• For placing & leveling the machine
- Select flat & firm floor.
- Maintain more than 15 cm gap between the
side of drain hose and the wall.
- The base openings must not be obstructed by
carpeting when the washing machine is
installed on a carpeted floor.
NOTE
• The machine has mobility function by manual
intervention, care to be taken to avoid any body
parts coming under wheels.
• Install the washing machine on a horizontal
support. Otherwise, it may cause vibration and
noise.
• Incorrect installation may cause severe noise
and break down.
Connecting the earth wire (only for models with
two prong plug)
• Install the earth wire to prevent short- circuit due
to leaking current and electric shock.
• It is attached at the back of the washer. Connect
it to the metal water pipe. If the water pipe is
made of plastics, it does not have the earth
effect.
• Do not connect the earth wire
, lightning arrester, telephone connector, etc.
b
WARNING
• The appliance with two pronged plug must be
grounded.
Connecting the power plug
• Insert the power plug into the outlet.
• Before connecting the power plug, check if the
voltage setting of the washer matches the outlet
voltage.
• If AC outlet with ground terminal is used,
grounding is not needed. If not, never forget
earthing (earthing method above).
• The appliance must be positioned so that the
plug is accessible.
Other earthing method
• After connecting the earth wire
cooper plate , bury it atleast 75 cm deep under
b
the wet ground.
• Connect the earth wire
outlet.
to the gas pipe
a
to the earth
a
to the earthing-only
c