Install Lock Bracket - ABB EntelliGuard AKD-5 Installation Manual

Install Lock Bracket (AK-25 Cabinet Only)
 Ensure only qualified personnel install, operate, service, and maintain all electrical
equipment.
1. Check that the retrofitted EntelliGuard cassette has been completely racked into the cabinet.
2. Slide the bracket back into position as shown in the image below
previously drilled with the holes on the locking bracket
Figure 24. Position Bracket
3. Secure the bracket to the side frame by using the two self-tapping screws provided with the kit
(Figure 26 and Figure
Tools required: Spanner, 0.2-inch drill bit, hand drill
25 EntelliGuard R Circuit Breaker Retrofill AKD-5 Installation Manual
27).
 It must be ensured that the supply power
to the compartment is turned off/
compartment is de-energized for all the
incoming and outgoing circuits of the LVS
prior to any work being conducted on it.

During the installation and related work on
the equipment, it must be ensured that the
operator is using the prescribed PPE for the
specified tasks.
(Figure 24)
(Figure 25).
Figure 25. Line Up Bracket
and line up the holes
DEH-41547