Advertisement
Mounting the speakers on a wall
The speaker can be mounted on a wall by using the holes
provided on the speakers' back panel.
The hole(s) on the speaker's back panel is arranged so that the
speaker can be mounted in either of the two configurations
shown by the following figures.
Upright mounting
Fasten wood screws onto a firm wall or wall support as shown in
the figure, and set the mounting holes onto the protruding
screws.
Make sure that the screw is caught securely at a narrow part of
the hole .
SETTING UP THE SPEAKERS
Side-long mounting
60mm
Diam. 4–5 mm
Min.
12 mm
4–5 mm
Wood screw
(Available at a
hardware store)
For the upright mounting, only one hole is provided.
As for the side-long mounting, two holes are provided. Be sure
to use these two holes as a set.
For upright
mounting
For side-long
mounting
WARNING:
* Each speaker weighs 1.4 kg (3 lbs. 1 oz.). Do not mount them
on thin plywood or soft wall surface material, as the screws
may come out of the flimsy surface, causing the speakers to
fall down and be damaged, or result in personal injury.
* Do not fasten the speakers to walls with nails, adhesives, or
other unsound hardware. Long-term use and vibrations may
cause them to fall down.
* To avoid accidents resulting from tripping over loose speaker
cables, fix them to the wall.
SPECIFICATIONS
Type..................................Full-range bass-reflex speaker system
Speaker Unit ...............................................10 cm cone full-range
Nominal Impedance ...........................................................6 ohms
Frequency Response ............................................70 Hz – 20 kHz
Nominal Input Power ..............................................................25W
Maximum Input Power ...........................................................80W
Sensitivity.....................................................................90 dB/W·m
Dimensions (WxHxD)....................................180 x 220 x 101 mm
Weight .............................................................1.4 kg (3 lbs. 1 oz.)
Accessories ............................................Speaker cable (10m) x 2
* Specifications subject to change without notice due to product
improvements.
* Care should be taken not to exceed the input power values
noted above.
For side-long
mounting
Magnetic shielding type
(7-1/16" x 8-11/16" x 4")
Printed in China
V 228210
Advertisement
