Table of Contents
Advertisement
Connection to the mains supply
Important
This appliance must be earthed!
Our company shall not held
responsible for any damage
caused by using the appliance
without earthed socket.
DANGER
Risk of electric shock, short
circuit or fire by unprofessional
installation!
The appliance may be connected
to the mains supply only by an
authorized qualified person and the
appliance is only guaranteed after
correct installation.
DANGER
Risk of electric shock, short
circuit or fire by damage of the
mains lead!
The mains lead must not be
clamped, bent or trapped or come
into contact with hot parts of the
appliance.
If the mains lead is damaged, it
must be replaced by a qualified
electrician.
•
The mains supply data must
correspond to the data specified on
the type plate of the appliance. The
type plate can be seen if the front door
is opened.
•
The appliance mains cable must
correspond to the specifications and
the power consumption; see
Technical
Data
,
page
5.
DANGER
Risk of electric shock!
Before starting any work on the
electrical installation, please
disconnect the appliance from the
mains supply.
1. This appliance must only be installed by
a qualified electrician, eg local
electricity company or a NICEIC
registed contractor, to a suitable
double-pole control unit with a
minimum contact clearance of 3 mm in
all poles, after appliance has been
installed in accordance with IEE
regulations. Failure to observe this
instruction may result in operational
problems and invalidation of the
appliance warranty.
Additional protection by a residual current
circuit breaker is recommended.
2. Open the terminal block cover with
screwdriver.
3. Pass the mains lead through the cable
clamp under the terminal and fix the
mains lead to main body with supplied
screw via cable tightener.
4. Connect the cables according to the
supplied diagram.
5. Close the cover of the terminal block
once the wiring is complete.
12 | EN
Advertisement
Table of Contents
