Simple Troubleshooting - Pyle PSBT105A User Manual

SIMPLE TROUBLE SHOOTING
Problems
No sound or faint sound
from speaker
Power indicator not on
Distorted sound from
from speaker.
Excessive feedback
Weak, Distorted Sound
Power Indicator Flickers
Excessive Hum or Noise
Shortened Battery Life
Battery CHARGE Indicator
Not Flickering when
plugged into AC Outlet
Possible Cause
1. Volume turned down.
2. Power switch is turned o .
1. Power switch is turned o .
2. Rechargeable Battery is
discharged.
3. Rechargeable battery is dead.
1. Volume set too high.
2. Excessive wind noise breath pops.
3. Input signal too strong.
1. Microphone too close or directly in
front of the speaker.
2. Volume set too high.
3. Microphone too far from sound
source. (requiring the volume to
be turned up to compensate)
1. Batteries level is low
1. Input Cable not shielded
1. Old or overused battery
2. Battery is not charged
for over 4-3 months.
1. Rechargeable Battery is dead.
2. Battery is not charged
for over 4-3 months.
Solution
1. Adjust volume
2. Turn power switch on
1. Turn power switch on.
2. Plug into AC outlet to recharge.
3. Replace battery and plug into AC
outlet to recharge.
1. Reduce volume
2. Use windscreen on wireless &
wired microphone
3. Adjust input signals.
1. Move microphone away
from the speaker.
2. Recharge.
3. Speak closer to the microphone or
move microphone closer to
sound source.
1. Plug into AC outlet to recharge.
1. Use shielded cable
1. Recharged or replace battery
2. Recharged or replace battery
1. Recharged or replace battery
2. Replace battery.
www.PyleUSA.com
5