Table of Contents
Advertisement
·
Your personal safety is a primary concern in the de-
sign and manufacture of our products. Unfortunately,
our efforts to provide safe equipment can be wiped
out by a single careless act of an operator or bystand-
er.
·
In addition to the design and configuration of equip-
ment, hazard control and accident prevention are de-
pendent upon the awareness, concern, prudence and
proper training of personnel involved in the operation,
transport, maintenance and storage of this equip-
ment.
·
It has been said, " The best safety device is an in-
formed, careful operator." We ask you to be that
kind of operator.
·
The operator must be properly trained. Operators
must be familiar with the equipment and tractor and
all safety practices before starting operation. Read
the safety information on pages 1, 5-6.
·
This box blade is designed for normal landscape us-
age.
·
Recommend blading speed for most conditions is
from two to five mph.
·
Maintain your implement with original repair parts to
ensure optimum performance.
MODIFICATIONS
·
It is the policy of the manufacturer to improve its prod-
ucts whenever possible and practical. We reserve the
right to make changes, improvements, and modifica-
tions at any time without incurring the obligation to
make such changes, improvements, and modifica-
tions on any implement sold previously.
OPERATION
ASSEMBLY
GENERAL
·
Your Series 233 Box blade is shipped with the three
Point hitch completely set up.
each step loosely to ensure fit. Use flat washers
with slotted holes
locknut is called for. Tighten hardware after parts are
installed according to the torque chart on page 3. Un-
less otherwise stated, all hardware is Grade 5. The
following assembly steps are given to minimize the
need for adjustment after assembly. Remember the
Left and right are determined by standing at the rear
of the implement and facing forward.
BEFORE OPERATION
1)
Tighten all loose hardware using the torque chart.
SEE ASSEMBLY. Replace any missing hardware. On
new machines, all hardware must be rechecked after
first few hours of operation.
2)
Replace any bent or broken parts.
3)
Refer to your Tractors Owners Manual for recom-
mended adjustments and weight distribution.
4)
Check equipment for signs of wear or damage. Re-
place if necessary. SEE MAINTAINANCE.
5)
Read the safety section of this manual to be sure of
all precautions.
8
Assemble parts for
. Always use lockwashers unless a
Advertisement
Table of Contents
