Table of Contents
Advertisement
the safety tube!
The safety tube must not be
clamped, bent or trapped or
come into contact with hot parts
of the appliance.
Connection to the mains supply
i]
This appliance must be
earthed!
Our company shall not be held
responsible for any damage
caused by using the appliance
without earthed socket.
Risk of electric shock, short
circuit or fire by unprofessional
installation!
The appliance may be connected
to the mains supply only by an
authorized qualified person and
the appliance is only guaranteed
after correct installation.
Risk of electric shock, short
circuit or fire by damage of the
mains lead!
The mains lead must not be
clamped, bent or trapped or
come into contact with hot parts
of the appliance.
If the mains lead is damaged, it
must be replaced by a qualified
electrician.
The mains supply data must
correspond to the data specified on
the rating plate of the appliance. The
rating plate is either seen when the
door or the lower cover is opened or it
is located at the rear wall of the
appliance depending on the appliance
type.
The supply cable of the appliance
must correspond to the specifications;
see technical data table Technical
specifications, page 5.
Æ
Risk of electric shock!
Before starting any work on the
electrical installation, please
disconnect the appliance from
the mains supply.
1. A mains lead is not supplied with
the appliance, It must connect a
mains lead to your appliance that
you would select from the table on
basis of the installation at your
home, following the instructions in
the wiring diagram.
If no all-pole separation from the mains
supply is possible, a separation
appliance must be connected with a
contact distance of 3 mm min. (fuses,
line safety switches, contactors) all
poles which should be adjacent to (but
not above) the appliance in
accordance with IEE regulation. Failure
to observe this instruction may result
in operational problems and
invalidation of the appliance warranty.
Additional protection by a residual
Current circuit breaker is
recommended.
2. Open the terminal block cover with
screwdriver.
3. Pass the mains lead through the
cable clamp under the terminal and
fix the mains lead to main body
with supplied screw via cable
tightener.
4. Connect the cables according to
the supplied diagram.
5. Close the cover of the terminal
block once the wiring is complete.
10 | EN
Advertisement
Table of Contents
