Table of Contents
Advertisement
| BT-H1350V
Location of Controls and Switches
AUTO
PAL SECAM NTSC NTSC
BLUE
SYNC
3.58
4.
EHE РАНЫ С
RGB-
CONTRAST
H-CENT
CHROMA
FILTER
сц
HEAD
APERTURE
CONTRAST
BRIGHTNESS
PHASE
CHROMA
VOLUME
PHONES
(1) Power Switch
(6) Blue Signal Only Switch
Power ON/OFF
Depress this switch to observe BLUE SIGNAL in
Black and White. This makes it easier to adjust
(2) Power Indicator
chrominance and hue (using SMPTE color bar
This indicator will be light when power is ON.
display) and increases visibility of video tape
dropouts and playback noise.
(3) Input indicators
These indicators will be light when it is selected
(7) Sync (INT/EXT) Selector Switch
input channel.
INT: The monitor operates on the sync signal
from the displayed composite video signal.
(4) Auto indicator
EXT: The monitor operates on an external sync
This indicator will be light when TV system
signal supplied from the EXT SYNC
selector switch is AUTO mode.
connector on the rear panel.
(5) TV System Selector Switch
Chroma Switch
This switch is normally set at AUTO.
Depress this switch to observe Black and White
However, if the picture can not be received at
picture.
Auto mode appropriately. Set the switch to the
desired position.
Advertisement
Table of Contents
