Advertisement
1. Close the door
To pull out the programme selector
2. Turn the tap on.
@ To pull out the programme selector
3. Press the programme selector and release it.
The knob comes out.
@ Switch on and select the programme
4. Turn the programme selector
The corresponding pilot lamp comes on.
@ To push in the programme selector
5. Press the programme selector in to the stop and
release it.
The knob is aligned with the control panel.
@ Note:
Pulling in and out the programme selector has no
influence on the operation of the dishwasher.
6. Select the additional functions, if desired,
the corresponding pilot lamp comes on.
After the ON button has been pressed the dishwasher
memorises all your data (programme and any additional
functions, including delay timer). These data will be re-
membered even after a power failure. These data cannot
be altered by using the push-buttons or the programme
selector!
@ To alter the programme
1. Keep the On button pressed down until
the Start pilot lamp goes out.
. Pull out the programme selector.
. Select the new programme.
. Push in the programme selector.
. Select any additional functions required.
. Press the On button.
@ ouanwn
End of the programme
The Start pilot light goes out.
The End pilot light on the programme progress
indicator comes on briefly.
@ Switching off
. Pull out the Programme selector.
. Turn the programme selector to position 0.
All the pilot lamps go out.
- Push in the Programme selector.
. Turn the tap off.
. Open the
door.
. Take out the crockery: empty the lower rack first.
aubw
N-=-
Advertisement
