HP 3314A Manual page 23

Model 3314A | Installation
LOCK LINK KIT
VERTICAL AND HORIZONTAL
HP PART NUMBER 5061-9694
The vertical and horizontal lock link hardware is used for locking together various bench and rack mountable
combinations of full and sub module cabinets of equal depths, sufficient horizontal links (12 front, 8 rear), to
form three side by side joints (up to 4 sub module instruments), and sufficient vertical links (4 front, 4 rear) to
form two sets of over-under joinings.*
CONTENTS
QTY PART NO.
4 VERTICAL LOCK LINK: FRONT 2.5. ades nceeexe yr teer ne a ea n Rs 1600-1423
8: MOX 08 x D PANHEAD S u l ze ok te OU EE RR wd XLI 0515-0887
4. VERTICAL LOCK LINK, REAR оса а ни а на и ава књ 0050-2168
8 МЗ5х0.6х 12 (90? )FLAT HEAD PLASTIC MOD .......................... 0515-1235
8 M3.5 x 0.6 x 8 (90?) FLAT HEAD METAL MOD ............................. 0515-1234
12 HORIZONTAL LOCK LINK, FRONT ........ БКТ Т ТТТ ТТТ 0050-2166
12 М4х07х6(90°) FLAT HEAD ........................................-... 0515-1055
6 'HORIZONTAL LOOK LINK, REAR ......................................... 0050-2167
12 M3.5 x 0.6 x 12 (90°) FLAT HEAD PLASTIC MOD .......................... 0515-1235
12 M3.5 x 0.6 x 8 (90°) FLAT HEAD METAL MOD ............................. 0515-1234
"INCH" HARDWARE
This kit also contains the equivalent "inch" hardware to attach the lock links to the "inch" cabinet frames.
AC № =
AC mnm
QTY CONTENTS PART NO.
8 6-32 x 0.188 PAN Head 2360-0330
20 6-32 x 0.312 FLAT HEAD, 100' 2360-0334
20 6-32 x 0.438 FLAT HEAD, 100' 2360-0360
12 8-32 x 0.250 FLAT HEAD, 100' 2510-0192
CAUTION
Please verify the "inch" front- or rear frame as follows:
"Inch" Front- or Rear Frame 5020-....
"Metric" Front- or Rear Frame 5021-....
(These P/N's are diecast into the top and rear of the frames).
INSTRUCTIONS
Vertical Locking
. Remove top trim strip from bottom front frame.
. Attach front vertical lock links to bottom front frame using 2 M3. 5 x 0.6 pan hd. screws per
link.
. Slide top cabinet back to lock front frames together.
. Attach rear vertical lock links over appropriate rear bosses using 2 M3.5 x 0.6 F.H.M.
Screws per link.
Horizontal Locking
. Remove appropriate side trim strips.
. Attach front horizontal lock links to front frames using 1 M4x0.7 F.H.M. screw per link.
Opposing links must be installed to interlock.
. Press cabinets together, slide left cabinet back to lock front frames.
. Attach rear horizontal lock links over appropriate rear bosses using 2M3.5 x 0.6 F.H.M.
screws per link.
"Locking cabinet together horizontally in a configuration wider than 1 full module width or locking more than two sub
modules verticaily is not recommended.
MADE IN USA 2/85
LABEL NO. 5958-3333