Connecting A Flexpendant - ABB IRC5 Product Manual

2 Installation and commissioning

2.5.8 Connecting a FlexPendant

2.5.8 Connecting a FlexPendant
Location of FlexPendant connector
The FlexPendant connector on the Panel Mounted Controller is located on the front
of the controller.
xx1300001947
A
Connecting a FlexPendant
1
2
3
4
Continues on next page
80
A
FlexPendant connector
CAUTION
Always inspect the connector for dirt or damage before connecting it to the
controller. Clean or replace any damaged parts.
Action
Locate the FlexPendant socket connector
on the controller or operator's panel.
Plug in the FlexPendant cable connector.
Screw the connector lock ring firmly by
turning it clockwise.
The FlexPendant starts automatically when
connected and verifies that it has the cor-
rect software installed. If an update is
needed, this is shown.
© Copyright 2007-2024 ABB. All rights reserved.
Information
The controller must be in manual mode.
Updating the add-in FlexPendant SxTPU4
Software on page 81
Product manual - IRC5 Panel Mounted Controller
3HAC047137-001 Revision: AB