Leg Installation Place tabletop with bottom facing up on a soft surface to avoid scratching table. CAUTION Heavy object. Multi-person lift required. a) Standing–Height Angled Sleigh Legs with Support Braces Align leg and brace pilot holes on surface to identify location of self-tapping screws for bottom of leg.
Page 3
b | Seated-Height Angled Sleigh Legs Wood Screws c | Angled Post Legs Note: Bottom of each leg should sit inside of surface corner to avoid tripping hazard. Wood Screws Bottom of Leg...
Page 4
2-Piece Surface Installation Place tabletops with bottoms facing up on a soft surface to avoid scratching table. Lay joining hardware into slotted areas and tighten bolts. Align legs and braces to surface. Secure with provided hardware. Note: Since each table is handcrafted uniquely, measurements may vary when aligning legs at center.