Table of Contents
Advertisement
8. HANDLE GRI
DISASSEMBLY
e
Remove two screws
Fig. 8-4
Zoom switch board
AGC ON/OFF switch
o
Fig. 8-5
Fig. 8-1
o
Disconnect CN101
Remove two screws
Fig. 8-2
hold the handle
which
screws
Remove two screws
Handle strap
Fig. 8-3
26
•
Disconnect the connector CN208 from the Process
circuit board. (Fig. 8-1).
• Remove the two screws which hold the handle grip
left cover and remove the left cover. (Fig. 8-4 and 5)
CR Start/Stop
Switch board
Disconnect
CN208
•
Remove the two
strap. (Fig. 8-3)
•
Disassemble the camera as described in Section 2.
"DISASSEMBLY
PROCEDURE
FOR
ADJUST
MENT " on page 1.
• Disconnect the connector CN101 for the handle
grip from the Deflection circuit board. (Fig. 8-2)
•
Remove the two screws which hold the adjustable
handle grip to the chassis (Fig. 8 2) and remove the
handle grip
Advertisement
Table of Contents
