Table of Contents
Advertisement
17
Add
the Detergent
Close the lid
Finish
Caution & Note
®
►
k.
4
>
©> !► *
The WATER LEVEL will be set to a
higher level automatically if water is
already in the tub,or wet laundry is
loaded into the tub before starting.
*
With lightweight bulky loads, a low
WATER LEVEL willbe automatically
selected
* Changes to Water Temperature
(HOT/COLD) and wash level are
possible during operation.
(refer to page 14)
• Add the appropriate quantity of
Detergent as indicated by the
WATER LEVEL next to
WATER DETERGENT.
Or follow the Detergent
manufacturer's instructions
• Water Water level
will then be topped
up shorly. after the
wash has started to
supplement the
water the laundry
has absorbed.
• When the wash
program ends, the
chime will sound
for 10 seconds
before the Power
goes off
automatically.
©
►
•
When setting the WATER LEVEL
Manually,do not set to medium or lower to
prevent damage to laundry.
•
Washing with HOT water may damage the
laundry (Water is set to cold
automatically). Ensure that the load is
under 2kg.
•
In order to avoid and reduce wrinkles to
the laundry, the spin cycle may appear
slow.
As a result,the clothes may contain a
higher level of moisture or water.
•
Use neutral Detergent
appropriate for the
laundry.
•
When washing woolens
use a mild Detergent
recommended for
washing wool.
§ ►
k
© Hi
© ►
•
When the water inlet pressure is greater
than 350kpa, The QUICK WASH course
takes approximately 19min.
•
Add the appropriate
quantity of Detergent as
indicated by the WATER
LEVEL next to
WATER DETERGENT.
Or follow the Detergent
manufacturer's instructions
©
►
k
<L>
©
►
►
k.
©>
•
It is normal for the tub to rotate slowly
and at low spin speed levels during
the actual wash cycle. This is part of
the wash action.
Advertisement
Table of Contents
