Overview
- LED Indicators
- Scan Window
- Scan Trigger
ACCESSORIES
Wall Mount
CORD ATTACHMENT/REMOVAL
HOST INTERFACES
NOTE: Cables may vary depending on configuration
TROUBLESHOOTING
Scanner not working
- No power to scanner
Check system power; ensure power supply, if required, is connected - Incorrect interface cable used
Ensure that correct interface cable is used - Interface/power cables are loose
Ensure all cable connections are secure
Scanner decoding bar code, but data not transmitting to host
- Scanner not programmed for correct host interface
Scan appropriate host parameter bar codes - Interface cable is loose
Ensure all cable connections are secure
Scanner not decoding bar code
- Scanner not programmed for bar code type
Ensure scanner is programmed to read type of bar code being scanned - Bar code unreadable
Ensure bar code is not defaced; try scanning test bar code of same bar code type - Distance between scanner and bar code incorrect
Move scanner closer to or further from bar code
Scanner decoding bar code, but data not transmitting to host
- Scanner not programmed for correct host interface
Scan appropriate host parameter bar codes - Interface cable is loose
Ensure all cable connections are secure
Scanned data incorrectly displayed on host
- Scanner not programmed for correct host interface
Scan appropriate host parameter bar codes
DS9808 PROGRAMMING BAR CODES
Set Defaults
Enne Feed)
USB Host Types
RS-232 Host Types
IBM 46XX Host Types
Keyboard Wedge Host Types
Scan ONE of the following country types
OPTIMUM SCANNING
Hands-Free Scanning
Hand-Held Scanning
Aiming
OPTIMUM ARM POSITION
AVOID EXTREME WRIST ANGLES
AVOID BENDING AND REACHING
Alternate left and right hands taking breaks and task rotation recommended
BEEPER INDICATIONS
Standard Use
- Low/medium/high beep
Power up - Short medium beep
Bar code decoded - 4 long low beeps
Transmission error detected; data is ignored
- High/low/high/low beep
Successful parameter setting - High/low beep
Correct programming sequence performed - Low/high beep
Incorrect programming sequence or "Cancel" bar code scanned
LED INDICATIONS
Hand-Held Scanning
- Off
Scanner is on and ready to scan, or no power to scanner - Green
Bar code is successfully decoded - Red
Transmission error
Hands-Free (Presentation) Scanning
- Off
No power to scanner - Green
Scanner is ready to scan - Off Momentarily
Bar code is successfully decoded - Red
Transmission Error
123SCAN2
123Scan 2 is an easy-to-use, PC-based software tool that enables rapid and easy customized setup via a bar code or USB cable. For more information, visit: http://www.zebra.com/123Scan2.
If you have a problem using the equipment, contact your facility's Technical or Systems Support. If there is a problem with the equipment, they will contact the Zebra Support at: http://www.zebra.com/support.
For the latest version of this guide go to: http://www.zebra.com/support.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Need Assistance?
Do you have a question about the DS9808 that isn't answered in the manual? Leave your question here.