Table of Contents
Advertisement
TROUBLESHOOTING
If a fault occurs, first check the points listed
WARNING
below before taking the set for repair.
Under no circumstance should you try to
|f
y0U
are unable to solve a problem by
repair the set yourself as this will
following these hints, consult your dealer or
invalidate the guarantee.
service center.
1
Problem
Possible cause
Solution
No sound.
VOLUME is not adjusted.
Adjust volume.
no power
Headphone is connected.
Disconnect headphone.
Mains cable is not securely connected.
Connect mains cable properly.
Batteries are flat.
Insert fresh batteries.
Batteries are inserted incorrectly.
Insert batteries correctly.
Trying to change over from mains to
battery supply without removing the plug.
Remove the mains plug from the
unit's AC MAINS inlet.
No reaction to
Electrostatic discharge,
operation of any keys
Disconnect the set from power supply,
reconnect after a few seconds.
Poor radio reception Weak radio signal.
Direct the antenna for optimum
reception.
interference caused by vicinity of electrical
equipment like TVs, computers, engines, etc..
Keep the radio away from electrical
equipment.
no o' !SL
or
The CD is badly scratched or dirty.
Replace or clean the CD.
Ed Err
indication No CD is inserted.
Insert a CD.
The CD is inserted upside down.
Insert CD with label upwards.
The laser lens is steamed up.
Wait until the lens has cleared.
The CD skips tracks The CD is damaged or dirty.
Replace or clean the CD.
shuffle or program is active.
Switch off shuffle or program play.
Poor cassette
Dust and dirt on the heads, capstans or
Clean heads, capstans, and pressure
sound quality
pressure rollers.
rollers.
Use of unsuitable cassette types
(METAL or CHROME) for recording.
Only use NORMAL type cassettes for
recording.
Recording does
not work
Cassette tab[s) may be snapped off.
Apply a piece of adhesive tape over
the aperture.
Remote control does * Batteries are inserted incorrectly.
Insert batteries correctly.
not function properly Batteries are flat.
Insert fresh batteries.
Distance to the set is too large.
Reduce distance.
15
Advertisement
Table of Contents
