Panasonic CQ-H03EG Service Manual page 4

CQ-HO3EG/EE
a
| General Operation
The General Operation should be observed at all times when operating
radio or tape.
1. Power Switch (SW)
i
on
After every use,
switch the power off.
2. Select operating mode.
RADIO: See page 5,
TAPE: See page 7.
P-SET Oe
{Ile
4. Bass / Treble Controls
(BASS / TRE)
CAN
MIN >) MAX
3. © Volume Control (VOL)
E
TRE
Sov. na,
After every
f, =
4 use, set the
volume to MIN MAX
MIN MAX = minimum position.
® Balance Control (PULL BAL) 5. Loudness Button (LOUD)
Switch on when listening
beeline we at low volume.
Kod *%. Left/Right Speakers ous is
4 + balance
Pull and turn. Depress Depress
t.
LEFT ® RIGHT In. eM
t. on ¥ SB ott
CQ-HO3EG/EE
| To Listen to the Radio
> Did you read the "General Operation" on page 4?
ae
1. Turn on power switch.
2. Press BAND to select FM (FM1/ FM2) or AM (LW/ MW)
3. @ Manual Tuning:
Press © for tuning to higher
frequency.
Press @ for tuning to lower
frequency.
@ Seek Tuning:
Press ® or @ and hold it for
more than half a second. Seek
tuning will operate and will stop
on the next station.
Repeat this operation again and
so On until the desired station is
reached.
FM Stereo Indicator
"FM/AM" Indicator
Radio Frequency
"To Set the Preset Station
Six AM and twelve FM stations can be preset in the electronic memory circuit.
1. Select radio band.
2. Tune in the station
either by manual
or seek tuning.
Radio Frequency H
Selected preset ——————
station number
3. Preset Station Selectors (1~6)
Hold one of the preset station selectors in for about
2 sec.. (The radio frequency display will blink once
when memory is activated.)
The memory has now been set.
Repeat the same methods for the remaining
selectors.
2.575