Table of Contents
Advertisement
Connections
Connect various external devices to the TV and switch input modes to
select an external device. For more information of external device's
connection, refer to the manual provided with each device.
Antenna/Cable
Connect the TV to a wall antenna socket with an RF cable (75 Ω).
• Use a signal splitter to use more than 2 TVs.
• If the image quality is poor, install a signal amplifier properly to
improve the image quality.
• If the image quality is poor with an antenna connected, try to realign
the antenna in the correct direction.
• An antenna cable and converter are not supplied.
• For a location that is not supported with ULTRA HD broadcasting,
this TV cannot receive ULTRA HD broadcasts directly. (Depending on
model)
Satellite dish
Connect the TV to a satellite dish to a satellite socket with a satellite RF
cable (75 Ω). (Depending on model)
CI module
View the encrypted (pay) services in digital TV mode. (Depending on
model)
• Check if the CI module is inserted into the COMMON INTERFACE in the
right direction. If the module is not inserted properly, this can cause
damage to the TV and the COMMON INTERFACE.
• If the TV does not display any video and audio when CI+ CAM is
connected, please contact to the Terrestrial/Cable/Satellite Service
Operator.
Other connections
Connect your TV to external devices. For the best picture and audio
quality, connect the external device and the TV with the HDMI cable.
Some separate cable is not provided.
HDMI
• Supported HDMI Audio format:
(Depending on model)
Dolby Digital / Dolby Digital Plus (32 kHz / 44.1 kHz / 48 kHz),
PCM (32 kHz / 44.1 kHz / 48 kHz / 96 kHz / 192 kHz)
• If the device connected to Input Port also supports HDMI
Deep Colour, your picture may be clearer. However, if the
device doesn't support it, it may not work properly. In
that case, change the TV's [HDMI Deep Colour] setting
to off.
(Depending on model)
•
[HDMI Settings]
(Depending on model)
USB
Some USB Hubs may not work. If a USB device connected through a USB
Hub is not detected, connect it directly to the USB port on the TV.
• It is recommended that you use a USB hub or USB HDD with a power
supply. (If the power supplied is not sufficient, the USB storage device
may not be detected properly.)
• It is recommended that you use an external USB HDD with a rated
voltage of 5 V of less and a rated current of 500 mA or less.
[General]
[External Devices]
[HDMI Deep Colour]
11
Advertisement
Table of Contents
