Table of Contents
Advertisement
en Cleaning and servicing
Set the volume of the signal
3
at the end of the programme:
0 (off) to 4 (very loud)
Set the volume of the signal
4
tone emitted when the but-
tons are pressed:
0 (off) to 4 (very loud)
Set the minimum installation
5
protection of the appliance to
10 A (LO) or 13 A (HI).
Note: The values for the en-
ergy label were determined
with a minimum installation
protection of 13 A. If the in-
stallation protection is
changed to 10 A, the pro-
gramme duration and energy
consumption will be in-
creased.
→ "Consumption values",
Page 39
1
Example
14.2 Changing the basic set-
tings
Set the programme selector to po-
1.
sition 1. → Page 29
Press Start/Reload
2.
same time, turn the programme
selector to position 2.
a The display shows the current
value.
Use the programme selector to se-
3.
lect the required basic setting.
→ Page 29
To change the value, press Drying
4.
/ Ready In
Time
To save the changes, switch off
5.
the appliance.
30
and, at the
.
Cleaning and servicing
15 Cleaning and servi-
cing
To keep your appliance working effi-
Cleaning and servicing
ciently for a long time, it is important
to clean and maintain it carefully.
15.1 Base unit
The base unit is the accessible area
at the bottom of the appliance in
which you will find the heat ex-
changer.
Opening the base unit
Requirements
¡ The appliance has cooled down
for 30 minutes.
¡ The appliance door is closed.
Open the maintenance flap.
1.
If you place a cloth beneath the
maintenance flap, you can collect
the remaining water from the base
unit.
Advertisement
Table of Contents
