Isofix Anchorage And Top-Tether Anchorage (Isofix Anchorage System) For Children; 僅 Securing A Child Restraint System Seat With; Top-Tether Anchorage" System - Kia Sonet 2024 Owner's Manual

Safety features of your vehicle
4. Push and pull on the Child Restraint
System to confirm that the seat belt is
holding it firmly in place.
If your Child Restraint System manufac-
turer recommends the use of a top-
tether with the lap/shoulder belt, see
"Securing a Child Restraint System seat
with "Top-tether Anchorage" system (if
equipped)" on page 3-27.
To remove the Child Restraint System,
press the release button on the buckle
and then pull the lap/shoulder belt out of
the Child Restraint System and allow the
seat belt to retract fully.
3 26
ISOFIX anchorage and top-tether anchorage (ISOFIX
anchorage system) for children
ISOFIX anchorage and top-
tether anchorage (ISOFIX
anchorage system) for chil-
dren (if equipped)
The ISOFIX system holds a Child
Restraint System during driving and in
an accident. This system is designed to
make installation of the Child Restraint
System easier and reduce the possibility
of improperly installing your Child
Restraint System. The ISOFIX system
uses anchors in the vehicle and attach-
ments on the Child Restraint System.
The ISOFIX system eliminates the need
to use seat belts to secure the Child
Restraint System to the rear seats.
ISOFIX anchorages are metal bars built
into the vehicle. There are two lower
anchors for each ISOFIX seating position
that will accommodate a Child Restraint
System with lower attachments.
To use the ISOFIX system in your vehi-
cle, you must have a Child Restraint Sys-
tem with ISOFIX attachments.
The Child Restraint System manufac-
turer will provide you with instructions
on how to use the Child Restraint Sys-
tem with its attachments for the ISOFIX
anchorages.
ISOFIX anchorages have been provided
in the left and right outboard rear seat-
ing positions. Their locations are shown
in the illustration.
WARNING
Do not attempt to install a Child
Restraint System using ISOFIX anchor-
ages in the rear centre seating position.
There are no ISOFIX anchorages pro-
vided for this seat. Using the outboard
seat anchorages, for the CRS installation