Table of Contents
Advertisement
System connections
Make connection as shown below. When connecting the related system components, refer also to the instruction manuals of the
related components.
Do not plug in the power lead until all connections are completed.
Audio cord
FM-DE EMPHASIS/
CHANNEL
SPACE
switch
(except for some areas.)
FM DE-EMPHASIS / CHANNEL SPACE SWITCH
(Except for some areas)
The FM DE-EMPHASIS / CHANNEL SPACE switch on the rear panel
is set to the correct setting that prevails in the area to which the unit
is shipped. However, if the FM DE-EMPHASIS / CHANNEL SPACE
setting is not matched to the area where the unit is to be used; for
instance, when you move from area 1 to area 2 or vice versa, de-
sired reception of AM / FM broadcasts is not expected. In this case,
change the FM DE-EMPHASIS / CHANNEL SPACE setting in accor-
dance with
the area
corresponding
to the table.
The
FM
DE-
EMPHASIS is switched over at the same time.
e@ When
changing
the setting of the FM
DE-EMPHASIS
/
CHANNEL SPACE switch, first disconnect the power cord,
then reset the channel space switch, connect the power
cord again, and turn the power on.
Amplifier A-1001
Some of the connected components are optional
depending
on areas.
For details, please consult
your nearest dealer.
For the connection of the AC cords incase of sys-
tem connection, please refer to the connection dia-
gram provided with the A-1001
amplifier.
AC110-120V-<a_ be AC220-240V-
e
TO AC OUTLET
AC voltage selector
(except for some areas.)
CHANNEL
SPACE freq.
f U.S.A., Canada,
1
FM
DE-EMPHASIS
75s
can countries
AM: 10kHz
Other countries
FM: SOkHz
AM: 9kHz
FMSOkHz
FM100kHz
AM SkHz AM 10kHz
CHANNEL SPACE
and South Ameri-|
FM: 100kHz
2
DE-EMPHASIS
50us Cc] 75ys
1. Connect all cords firmly. If connections are loose, there could be loss of sound or noise produced.
2, When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugg-4g/unplugging
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Advertisement
Table of Contents
