Husqvarna Z572XS Operator's Manual page 20

2. Connect the other end of the red cable to
the POSITIVE battery terminal (+) on the fully
charged battery (B).
WARNING:
the ends of the red cable against the
chassis.
3. Connect one end of the black cable to the
NEGATIVE battery terminal (-) on the fully
charged battery (C).
4. Connect the other end of the black cable to a
CHASSIS GROUND (D), away from the fuel tank
and the battery.
To remove the jumper cables
Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
To remove and install the battery
1. Fold the seat forward. Refer to
on page 12 .
2. Remove the bolt and the nut from the battery
bracket and remove the battery bracket from the
battery.
3. Use 2 wrenches to disconnect the black battery
cable from the negative (–) terminal on the
battery.
4. Use 2 wrenches to disconnect the red battery
cable from the positive (+) terminal on the
battery.
5. Carefully remove the battery from the product.
6. Install in the opposite sequence.
To adjust the tracking speed
If the product does not move straight forward, the
tracking speed must be adjusted.
20
Do not short circuit
To fold the seat
WARNING:
tracking speed in an open area without
bystanders.
1. Do a check of the tire pressure. Refer to
pressure on page 20 .
2. Turn the tracking controls out until they are flush
with the nuts. Refer to
3 for the location of the tracking controls.
3. Start the product.
4. Move the control levers forward fully and operate
the product at full throttle.
5. Turn the tracking control on the right side
gradually until the product starts to move right.
6. Turn the tracking control on the left side
gradually until the product starts to move straight
forward.
Tire pressure
Make sure that the tire pressure is correct in all 4
Technical data on page 29 .
tires. Refer to
To remove and install the front
wheels
1. Remove the nut and the bolt to remove the front
wheels from the forks.
2. Install in the opposite sequence. Torque the nut
and bolt to 45 ft-lbs / 61 Nm.
To adjust the anti-scalp rollers
The anti-scalp rollers keep the cutting deck in the
correct position on the ground and prevent lawn
scalping in most terrain conditions. The anti-scalp
rollers can be set in 3 positions for different lengths
of grass:
• Top position: 1.5–2.5 in. / 38–64 mm grass.
• Middle position: 2.5–4 in. / 64–102 mm grass.
• Bottom position: 4–5 in. / 102–127 mm grass.
1. Park the product on level ground and stop the
engine.
Always adjust the
Tire
Product overview on page
2320 - 001 - 29.11.2023