DOK-CONTRL-S20*PSDI*8*-AP02-EN-P
IndraControl S20 Module With Safe Digital Inputs S20-PSDI-8/4
5.1.4
Mounting and removing modules
Mounting the
bus base module
Snapping on and removing
the electronics module
DBR Automation is Bosch Rexroth Oficial Sales Partner. Interested in products or technical support? www.dbrautomation.com | +34951709474 | comercial@dbrautomation.com
A
B
A
B
Bosch Rexroth AG
Assembly, removal, and electrical installation
•
Place all bus base modules required for
the station on the DIN rail (A).
•
Push the bus base modules into the
bus coupler connection or the previous
bus base module (B).
Snap on
•
Place the electronics module vertically
on the corresponding bus base module
on the DIN rail until it snaps into place
with a click.
Make sure that the device connector for
the bus base connection is situated
above the corresponding socket on the
bus base module.
Remove
•
Before removing the module, remove
A
all connectors.
•
Insert a suitable tool (e.g., bladed
screwdriver) in the upper and lower
snap-on mechanisms (base latches) of
the module one after the other to re-
lease it (A).
•
Remove the module perpendicular to
the DIN rail (B).
27/102