13. ENVIRONMENTAL CONCERNS..............26 WE’RE THINKING OF YOU Thank you for purchasing an Electrolux appliance. You’ve chosen a product that brings with it decades of professional experience and innovation. Ingenious and stylish, it has been designed with you in mind. So whenever you use it, you can be safe in the knowledge that you’ll get great results every time.
Page 3
ENGLISH responsible for any injuries or damage that are the result of incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference. 1.1 Children and vulnerable people safety This appliance can be used by children aged from 8 •...
The operating water pressure (minimum and • maximum) must be between 0.5 (0.05) / 10 (1.0) bar (MPa) Follow the maximum number of 9 place settings. • If the supply cord is damaged, it must be replaced by •...
Page 5
ENGLISH 2.4 Use • Make sure not to cause damage to the mains plug and to the mains • Do not put flammable products or cable. Should the mains cable need to items that are wet with flammable be replaced, this must be carried out products in, near or on the appliance.
2.6 Disposal separately: These lamps are intended to withstand extreme physical conditions in household appliances, WARNING! such as temperature, vibration, Risk of injury or suffocation. humidity, or are intended to signal • Disconnect the appliance from the information about the operational mains supply.
ENGLISH 4. CONTROL PANEL On/Off button / Reset button ExtraPower button Delay Start button AUTO Sense button Indicators MY TIME selection bar 4.1 Indicators Indicator Description ECO programme indicator. It indicates the most environmentally friendly programme selection for a normally soiled load. Refer to "Programme selection".
Page 8
5.3 Options This is the standard programme for test institutes. You can adjust the programme selection to your needs by activating options. 5.2 AUTO Sense The AUTO Sense programme ExtraPower automatically adjusts the dishwashing cycle to the type of load.
ENGLISH Consumption values Water (l) Energy (kWh) Duration (min) 1) 2) Programme 30min 7.9 - 9.7 0.543 - 0.664 Pre-rinse 2.8 - 3.4 0.011 - 0.014 90min 8.5 - 10.4 0.743 - 0.909 0.779 AUTO Sense 8.0 - 10.7 0.683 - 1.047 120 - 170 Machine Care 7.4 - 8.9...
Page 10
You can change the basic settings in C. Next button setting mode. Use Previous and Next to switch between the basic settings and to When the appliance is in setting mode, change their value. the indicators on the control panel represent available settings.
Page 11
ENGLISH The higher the content of these minerals, your area. Your local water authority can the harder your water is. Water hardness advise you on the hardness of the water is measured in equivalent scales. in your area. Set the right level of the water softener to assure good washing The water softener should be adjusted results.
Page 12
To deactivate the rinse aid dispenser and duration, unless it occurs in the middle of indicator, set the level of rinse aid to 0. a programme or at the end of a 6.4 End sound...
ENGLISH 6.6 Key tones The buttons on the control panel make a click sound when you press them. You can deactivate this sound. 7. BEFORE FIRST USE 1. Make sure that the current level of the water softener agrees with the hardness of the water supply.
7.2 How to fill the rinse aid CAUTION! dispenser Only use rinse aid designed specifically for dishwashers. 1. Press the release element (A) to open the lid (B). 2. Pour the rinse aid in the dispenser (C) until the liquid reaches the marking "FILL".
Page 15
ENGLISH 8.2 How to select and start a 8.6 How to delay the start of a programme using MY TIME programme selection bar You can delay the start of the selected programme by 3 hours. 1. Press the button dedicated to the programme you want to select.
• When the programme is completed. If the door is opened for • After 5 minutes if a programme was more than 30 seconds not started. during the drying phase, the running programme ends. It 8.11 End of the programme does not happen if the door is opened by AirDry function.
Page 17
ENGLISH detergent based on the water • The correct quantity of detergent is hardness. Refer to the instructions on used. the detergent packaging. 9.5 Loading the baskets • Always use the correct quantity of rinse aid. Insufficient dosage of rinse •...
10. CARE AND CLEANING • Do not use abrasive products, WARNING! abrasive cleaning pads, sharp tools, Before any maintenance strong chemicals, scourer or solvents. other than running the • Wipe clean the door, including the programme Machine Care, rubber gasket, once a week.
Page 19
ENGLISH 5. Make sure that there are no residues of food or soil in or around the edge 1. Turn the filter (B) counterclockwise of the sump. and remove it. 6. Put back in place the flat filter (A). Make sure that it is correctly positioned under the 2 guides.
Page 20
10.6 Cleaning the lower spray installed in the duct (A) with the mounting elements (C). We recommend to clean the lower spray arm regularly to prevent soil from clogging the holes. Clogged holes can cause unsatisfactory washing results. 1. To remove the lower spray arm, pull it upwards.
ENGLISH 11. TROUBLESHOOTING to contact an Authorised Service WARNING! Centre. Improper repair of the Refer to the below table for information appliance may pose a on possible problems. danger to the safety of the user. Any repairs must be With some problems, the lights related to performed by qualified MY TIME selection bar flash personnel.
Page 22
Problem and alarm code Possible cause and solution The appliance does not • Make sure that the sink spigot is not clogged. drain the water. • Make sure that the interior filter system is not clog‐ • The lights related to ged.
Page 23
ENGLISH Problem and alarm code Possible cause and solution Technical malfunction of • Switch the appliance off and on. the appliance. • The lights related to MY TIME selection bar flash 12 times intermit‐ tently. • An acoustic signal sounds intermittently. The level of water inside •...
Page 24
WARNING! We do not recommend using the appliance until the problem has been completely fixed. Unplug the appliance and do not plug it in again until you are certain that it operates correctly. 11.1 The dishwashing and drying results are not satisfactory...
ENGLISH Problem Possible cause and solution There are residues of deter‐ • The detergent tablet was stuck in the dispenser gent in the dispenser at the and was not washed away by water. end of the programme. • Water cannot wash away the detergent from the dispenser.
12.1 Link to the EU EPREL EPREL database using the link https:// eprel.ec.europa.eu and the model name database and product number that you can find on the rating plate of the appliance. Refer to The QR code on the energy label the chapter "Product description".