Advertisement
Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and
5
facing the front. Secure using two 1/4-20x1½" screws, 7mm lock washers, and 7mm flat washers on each side.
NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN
ASSEMBLED TO CART.
On back of grill, place upper back panel between side panels and
6
above lower back panel. Secure upper back panel, in lower holes,
using one 1/4-20x1½" screw, 7mm lock washer, and 7mm flat
washer on each side. Do not fully tighten screws until side shelf
installation is complete in later steps.
Front brace
Door
Hinge Pin
1/4-20x1½"
7mm lock
screw
washer
Upper back panel
1/4-20x1½" screw
7mm lock
washer
7mm flat
washer
7mm flat
washer
466268008 • 17
Advertisement
